ABB FPBA-01 Handbuch PDF herunterladen (Seite 15)

Fieldbus control description

After the module configuration parameters have been set, the drive control

parameters (see section Drive control parameters) must be checked and adjusted

when necessary.

The new settings will take effect when the drive is powered up the next time (before

powering off the drive, wait at least 1 minute), or when parameter 51.27 FBA PAR

REFRESH is activated.

Drive control parameters

The Setting for fieldbus control column gives the value to use when the fieldbus

interface is the desired source or destination for that particular signal. The Function/

Information column gives a description of the parameter.

TRANSMITTED DATA SELECTION

52.01 FBA DATA IN1

… 52.12 FBA DATA

IN12

4…6

14…16

101…9999

Defines the data transmitted from drive to fieldbus controller.

Note: If the selected data is 32 bits long, two parameters are reserved

for the transmission.

53.01 FBA DATA

OUT1 … 53.12 FBA

DATA OUT12

1…3

11…13

1001…9999

Defines the data transmitted from fieldbus controller to drive.

Note: If the selected data is 32 bits long, two parameters are reserved

for the transmission.

Note: In the User’s Manual of the fieldbus adapter module, the parameter group number is 3 or C for parameters

52.01…52.12 and 2 or B for parameters 53.01…53.12.

Parameter

Setting for

fieldbus control

Function/Information

CONTROL COMMAND SOURCE SELECTION

10.01 EXT1 START

FUNC

(3) FBA Selects fieldbus as the source for the start and stop commands when

EXT1 is selected as the active control location.

10.04 EXT2 START

FUNC

(3) FBA Selects fieldbus as the source for the start and stop commands when

EXT2 is selected as the active control location.

24.01 SPEED REF1 SEL (3) FBA REF1

(4) FBA REF2

Fieldbus reference REF1 or REF2 is used as speed reference 1.

24.02 SPEED REF2 SEL (3) FBA REF1

(4) FBA REF2

Fieldbus reference REF1 or REF2 is used as speed reference 2.

32.01 TORQ REF1 SEL (3) FBA REF1

(4) FBA REF2

Fieldbus reference REF1 or REF2 is used as torque reference 1.

32.02 TORQ REF ADD

SEL

(3) FBA REF1

(4) FBA REF2

Fieldbus reference REF1 or REF2 is used for torque reference

addition.

SYSTEM CONTROL INPUTS

16.07 PARAM SAVE (0) DONE

(1) SAVE

Saves parameter value changes (including those made through

fieldbus control) to permanent memory.

Parameter

Setting for

fieldbus control

Function/Information

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 133 134

Kommentare zu diesen Handbüchern

Keine Kommentare

ABB FPBA-01 Handbuch Seite 15

Kommentare zu diesen Handbüchern