ABB FDNA-01 Bedienungsanleitung PDF herunterladen (Seite 44)

Communication profiles

ODVA Output Attributes

This section briefly describes the instances found in the ODVA

AC/DC Drive Profiles output assemblies. Not all attributes listed

here will be supported by all output assembly instances.

Run Forward & Run Reverse (Control Supervisor Object)

These attributes are used to assert run and stop commands to

Control Supervisor Object state machine (see “State” below)

according to the following table.

Table 10. Run/Stop event matrix

Fault Reset (Control Supervisor Object)

This attribute resets a drive fault on a transition from zero to one if

the condition that caused the fault has been cleared.

Net Ctrl (Control Supervisor Object)

This attribute requests that the drive Run/Stop command be

supplied

locally (Net Ctrl = 0) or by the network (Net Ctrl = 1).

Net Ref (AC/DC Drive Object)

This attribute requests that the drive speed and torque references

be supplied

locally (Net Ref = 0) or by the network (Net Ref = 1).

RunFwd RunRev Trigger event Run type

00StopN/A

→ 10 Run RunFwd

→ 1 Run RunRev

→ 10 → 1 No Action N/A

1 1 No Action N/A

→ 1 1 Run RunRev

→ 0 Run RunFwd

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 113 114

Keine Kommentare

ABB FDNA-01 Bedienungsanleitung Seite 44