ABB FDNA-01 Bedienungsanleitung PDF herunterladen (Seite 29)

Drive configuration

Overview

This chapter gives information on configuring the FDNA-01

DeviceNet Adapter module.

DeviceNet connection configuration

After the FDNA-01 DeviceNet Adapter module has been

mechanically and electrically installed according to the instructions

in chapters "Mechanical installation" and "Electrical installation",

the drive must be prepared for communication with the module.

The detailed procedure of activating the module for DeviceNet

communication with the drive is dependent on the drive type.

Normally, a parameter must be adjusted to activate the

communication (see the drive documentation).

As communication between the drive and the FDNA-01 is

established, several configuration parameters are copied to the

drive. These parameters (Tables 3, 8 and 9) must be checked first

and adjusted where necessary. The alternative selections for

these parameters are discussed in more detail below the tables.

Note: The new settings take effect only when the module is

powered up the next time or when a ‘Fieldbus Adapter parameter

refresh’ is given (see the drive documentation).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 113 114

Keine Kommentare

ABB FDNA-01 Bedienungsanleitung Seite 29