ABB ACH550 Bedienungsanleitung PDF herunterladen (Seite 55)

FLN Protocol Technical Data

Detailed Point Descriptions

FLN Detailed Point Descriptions

Point Description

Drive

Parameter

1 CTRL ADDRESS The FLN address of the drive. It can be set by FLN and by

the panel.

5302

2 APPLICATION The Application ID for FLN on the ACH550. This ID is

assigned by Siemens for each unique application. It

correlates directly to a particular point list approved at the

time of release. Therefore, this point list shall remain fixed

once approval is granted. Any changes to the point list shall

require a new Application ID and re-approval by Siemens.

The Application ID assigned to ACH550 is 2934.

3 FREQ OUTPUT The output frequency applied to the motor, in Hertz. 0103

4 PCT OUTPUT The ratio of output frequency or speed to the corresponding

maximum rating, depending on control mode.

• For scalar mode, it is the ratio of Output Frequency

(parameter 0103) to Maximum Frequency (parameter

2008).

• For speed mode, it is the ratio Speed (parameter 0102) to

Maximum Speed (2002).

None. This

ratio is

calculated

by the FLN

application.

5 SPEED The calculated speed of the motor, in RPM. 0102

6 CURRENT The measured output current. 0104

7 TORQUE The calculated output torque of the motor as a percentage of

nominal torque.

0105

8 POWER The measured output power in KW. The FLN point definition

also supports horsepower by selecting English units.

0106

DRIVE TEMP The measured heatsink temperature, in

° C. The FLN point

definition also supports

° F by selecting English units.

0110

10 DRIVE KWH The drive's cumulative power consumption in kilowatt-hours.

This value may be reset by commanding FLN point 49,

RESET KWH.

0115

11 DRIVE MWH The drive's cumulative power consumption in megawatt

hours. This value cannot be reset.

0141

12 RUN TIME The drive's cumulative run time in hours. This value may be

reset by commanding FLN point 48, RESET RUN TIME.

0114

13 DC BUS VOLT The DC bus voltage level of the drive. 0107

14 OUTPUT VOLT The AC output voltage applied to the motor. 0109

15 PRC PID FBCK The Process PID feedback signal. 0130

16 PRC PID DEV The deviation of the Process PID output signal from its

setpoint.

0132

17 MOTOR TEMP The measured motor temperature as set up in Group 35. 0145

18 ROTATION CNT The motor's cumulative revolution count, in mega-

revolutions.

0142

19 N/A

20 OVRD TIME 1 of the 5 mandatory FLN points required for compatibility

with Siemens control systems. It has no functionality in the

drive application.

None

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 61 62

Kommentare zu diesen Handbüchern

Keine Kommentare

ABB ACH550 Bedienungsanleitung Seite 55

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ABB ACH550